NSi Industries DGLC Old Series - Manual (Page 8)

MO, TU, WE, TH, FR, SA
SU, MO, TU, WE, TH, FR, SA
Individual days: SU, MO, TU, WE, TH, FR, SA,
and D for Special Day (usually a holiday).
A special holiday schedule can be entered if
you want to be able to repeat this particular
schedule on holidays only.
2. Press HOUR key to set hour {check AM/PM}.
3. Press MIN key to set minutes.
4. Once desired days are set, press ON/OFF key
to set ON or OFF event. If all of the information
you entered is correct, press ENTER key to
store the event.
Display will now show --:--02. This tells you
that the first event has been entered, and that
the unit is ready to accept the second entry.
Repeat preceding steps 1 to 4 to set more
schedule events.
Note: When the unit is returned to the run
mode, check the load status of the current
setting. It it is showing OFF but should be
ON, press the override key since the unit
does not “look back” to the setting just
entered. However, the unit will correct itself
at the next scheduled event and no further
alteration will be necessary.
SPECIAL DAY (HOLIDAY)
To execute this schedule at any time, simply
press the SP DAY key while the unit is in the RUN
mode. A letter “D” will appear in the upper right
corner and the Special Day schedule (previously
set) will repeat for as many days as you want. If
no schedule was entered, the circuit #1 load will
not turn ON.
To return to normal 7 day program operation,
press the SP DAY key again and the letter “D” will
disappear, indicating regular program operation.
REVIEW/MODIFY/ADD/DELETE
REVIEW: Reviewing is done in the set mode.
Press mode key until first setting appears.
Pressing the ENTER button will advance the
counter (which appears in the two digits on the
7
right) and shows you the next schedule event
entered. Events are numbered based on the order
with which they were entered, and not on when
they will be executed, so the first event you set
will be #01, the second #02, etc...
MODIFY: During the review process, the DAY
HOUR, MIN, and ON/OFF keys can all be used to
modify the settings. You can use the first three
keys to modify when the event will take place, and
the ON/OFF key to change an ON event to an
OFF event, or visa-versa. ONCE YOU HAVE
MADE THE NECESSARY CHANGE, YOU MUST
PRESS THE ENTER KEY (for each change) TO
STORE THEM.
ADD: You may add events at any time by press-
ing the mode key until the unit is in the set mode.
Then press ENTER key to advance to the next
open set point. Enter new schedule as indicated
in section “To Set Schedule”.
DELETE: If you choose to delete a schedule, sim-
ply modify the HOURS and MINUTES until the
time display reads --:--. This will occur after
scrolling past 11 P.M. with the HOUR key and
“59” with the MIN key, then press ENTER to
delete the event.
OVERRIDE (CIRCUIT #1 ONLY)
In order to temporarily change the current ON or
OFF status of a load, simply press the override
key. This can only be done when the unit is in the
RUN mode. The load status will flash indicating
that this is a change from a scheduled event.
In order to cancel the override, press override key
again.
NOTE: CIRCUIT #1 LOAD STATUS IS SHOWN
ON THE DISPLAY. CIRCUIT #2 LOAD WILL
TURN ON AT SUNSET AND OFF AT SUNRISE
EVERY DAY OF THE WEEK.
TORK
1 GROVE STREET, MT. VERNON, NY 10550 TEL: 914-664-3542
FAX: 914-664-5052
MLI-99(B)
®