NSi Industries Z400B - Manual (Page 9)

7
key in the time onwards of which you want to review and
press REVIEW or only press REVIEW, then the same
event stays on the display and channel LED starts
flashing.
To make any changes in REVIEW MODIFY, once the
channel indicator is flashing, press ADV until the partial
entry which you want to modify is flashing, i.e. Time,
ON/OFF events, etc. Then modify your entry. Then
advance to the end of a partial entry and press ENTER.
Example: 1987 ADVANCE
0606 ADVANCE
10:00 AM ENTER
NOTE THAT IN BOTH CASES ABOVE, THE ENTRY
WHICH WAS ON THE DISPLAY BEFORE IS NOT
AFFECTED AT ALL.
Reviewing from a different CHANNEL is done the same
way as above for both override and ASTRO feature.
REVIEW IN THE RUN POSITION
When the current time is being displayed, press REVIEW
and the YEAR-DATE-TIME SET LED begins to flash. This
is the PROTECTED REVIEW, although no special LED
indicates this.
ONLY REVIEW OF DATA IS PERMITTED AND NO
CHANGES.
The review process is exactly the same as in the SET
except you cannot press the advance key because no
changes are permitted.
At any time to return to standard run, press the ENTER
KEY.
SPECIFICATIONS
POWER INPUT ..........120/240VAC -15% to +10%VAC
50//60 Hz
Power Consumption ...12VA Max.
Output Circuits............SPDT Unpowered Contacts
Contact Rating............10 Amps Resistive @ 120/240VAC
10 Amps Resistive @ 30 VDC
1/4 H.P. @ 120VAC
1/3 HP @ 240 VAC
360 Watts Tungsten @ 120VAC
Operating Temp .........0° to +50°C (-35° to +50°C optional)
32°F to 120°F (-30° to +120°F)
(optional)
Battery Backup ...........Lithium, 6 months cumulative
Enclosure ...................NEMA 1 Surface Mount
Weight ........................6.5 lbs. (2.95 kg.)
Color ...........................Beige
Dimensions.................7 3/4” W x 12” H x 3 1/4” D
ADDENDUM
PLEASE FOLLOW THESE
PROCEDURES TO SET
DAYLIGHT SAVINGS
1. Place run/set switch in the set position.
2. Press MODE SELECT key until HOLIDAY LED
is lit constantly. shows on display.
Block #1 is flashing.
3. Press ADV key and 00:00 will show on display.
4. Key in the start date of DAYLIGHT SAVINGS.
5. Press AM/PM key until ON LED is lit . . . then
press ENTER.
6. Colon in display is now flashing.
7. Key in the END of DAYLIGHT SAVINGS . . .
MONTH/DAY.
8. Press AM/PM key. ON LED is now lit.
9. Press AM/PM KEY AGAIN. OFF LED is lit.
10. Press ENTER and the unit is now set for
DAYLIGHT SAVING.
11. PLEASE NOTE: If no dates are entered into
the unit for DAYLIGHT SAVINGS the unit will
automatically revert to STANDARD TIME.
12. If only one date is entered into the unit, i.e. the
beginning date or end date unit will again revert
back to STANDARD TIME.
REMEMBER TO ENTER BOTH
BEGINNING AND END DATES
TO INSTITUTE AUTOMATIC
DAYLIGHT SAVINGS.