AT&T Definity 7410 - Manual (Page 10)

Abbreviated Dialing (AD)
To program/reprogram 1
an AD button
Note: AD buttons must
first be assigned by your
System Manager.
2
3
4
5
On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you want
to program
Note: Each AD button will hold one complete phone
number or feature code.
Pick up handset [dial tone]
Press [ Program ] (if this button has been assigned to
your voice terminal)
or Dial Program code
[dial tone]
Press [ AD xxxxx ] to be programmed [dial tone]
Dial outside number, extension, or feature code you
want to program (up to 24 digits)
Note: If you are programming an outside number, be
sure to include a trunk code, if applicable.
6 Press [ # ] (on the dial pad)
[confirmation tone], [dial tone]
Number is stored
●
●
Repeat Steps 4-6 to program additional buttons
7 Hang up or press [ Drop/Test ] to end programming
To place an AD call 1 Press selected [ AD xxxxx ] [ringback tone]
●
Call is dialed (silently)
7