AT&T Definity 7410 - Manual (Page 20)

Select Ring (and Ringer Volume)
✔
To select a 1 While on-hook, press [ Select ]
personalized ring
● Green light goes on steadily
2 Press [ Conference/Ring ]
●
Green light next to [ Select ] winks; current ring
pattern plays and repeats every 4 seconds
3 Continue to press [ Conference/Ring ] to cycle through all
8 ring patterns
4 When you hear the desired ring pattern, press
[
Select ] again
●
Your new ring is set; green light next to [ Select ]
goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
start again. If you lose power after you have selected
your personalized ring, you will have to select your
ring pattern again.
To adjust ringer volume 1 To raise the volume, press the right half of the
if necessary Volume control button labeled [ ▲ ] ;
to lower the volume, press the left half of the
Volume control button labeled [ ▼ ]
(There are 8 possible volume settings.)
Self-Test
✔
To test the lights and 1 While on-hook, press [ Select ]
ringer of your voice
●
Green light goes on steadily
terminal
2 Press and hold [ Drop/Test ]
●
Ringer sounds; all lights go on steadily
3 Release [ Drop/Test ] to end test
●
Ringer and lights return to pretest state; green
light next to [
Select ] also goes off
Note: If ringer or lights do not respond during test,
notify your System Manager.
1 7