Thermo Fisher Scientific CyberComm Pro for CyberScan pH 1000 & 2500 - Manual (Page 16)

Instruction Manual CyberComm pH 1000/ pH 2500
19
Continue from Section 3.5
Refer back to Figure 13 on pg 16.
3.5.2 Measurement
Mode
This indicates the current mode of measurement mode, you can change the mode by clicking on the tab to
switch between the various parameters; pH, mV and Ion (Concentration). (Ion mode: available in pH 2500
only)
3.5.3 Show
Cursor
Use the ‘Show cursor’ function from the icon panel and a green guide line will show any point on the reading
curve having the exact measurement according to the mode chosen. Drag this guide along the horizontal
time axis and you can read the pH, mV or concentration values at any point in time.
3.5.4 Set Timer/ Memory/ Resolution/Temperature and Alarm
Set Time Interval of the meter. Minimum time interval is 1 minute and the maximum time interval is 23
hours and 59 minutes. Click OK to confirm the value. See Figure 17.
Figure 17: Set Timer
• Start/Stop Timer
Clicking the Start/Stop timer button will toggle between start and stop function of the timer. Upon
reaching the set time interval, the meter will start to beep.
• Set Memory Log Options
Enable Data Log on Ready
This option sets the meter to store data into meter memory whenever the READY annunciator appears
whenever the reading on the meter is stable for a few seconds. See Figure 17.
Note that the READY annunciator display must also be enabled for it to appear. By selecting the ON
option and OK button. To proceed to next function, select either OK or CANCEL button as shown in the
Data Log on Ready dialog box.
• Enable Data Log on Time Interval
This option allows the meter to store data into meter memory whenever the time set is met. The default
is 1 minute. This means a reading will be stored into the meter memory every 1 minute. As there are
only 16 memory locations, the oldest reading will be discarded. The maximum value is 1439 minutes
(23 hours and 59 minutes). To set the time interval, use the scroll bar to set the value in minutes.