Thermo Fisher Scientific CyberComm Pro for CyberScan pH 1000 & 2500 - Manual (Page 18)

Instruction Manual CyberComm pH 1000/ pH 2500
21
Set Alarm Limits
Allow both Low and High pH Alarm values to be set for pH, mV and Relative mV. The alarm dialog box will
appear as shown. See Figure 19.
Figure 19: Set Alarm Limits
To change the alarm value, use the scroll bar to increase or decrease value. After selecting the alarm
value, press OK button to confirm the set value.
3.5.5 Meter
On/Off
Switch on/off the meter.
3.5.6 Preset
Functions
a) Enable Auto Off
Checking or unchecking the option box will enable or disable the Auto Off respectively.
b) Enable Beep Warnings
To enable the meter beep, check the checkbox for this option. Unchecking the checkbox will disable the
meter beep.
c) Enable
“Ready”
Checking or unchecking the option box will enable or disable the “Ready” status respectively. Ready
annunciator will appear on the meter when the status is “READY”.
d) Enable
“Hold”
Checking or unchecking the option box will enable or disable the “Hold” option respectively.
3.5.7 Reset
Meter
Clicking this button will reset and stop the meter. All pH calibration points will be set to default and Relative
mV base value will be reset to 0.0 mV.
A warning screen as follows will prompt you to confirm if you want to erase all data. Click OK to continue to
reset meter. See Figure 20.
Figure 20: Reset Meter Warning