Thermo Fisher Scientific CyberComm Pro for CyberScan pH 1000 & 2500 - Manual (Page 9)

Instruction Manual CyberComm pH 1000/ pH 2500
12
3.1 Communication Settings (File)
See Figure 6.
To make changes, use the drop-down menu of each parameter to set to desired values to match the meter’s
settings. After selecting proper communication parameters, select OK button to proceed. Otherwise click
CANCEL if no change is made. To restore to factory default settings, click onto the Restore Defaults.
Figure 6: Communications Settings
a) Connect
Using
Select preferred connection port from the drop down menu; 1 or 2.
b) Baud Rate
Select preferred baud rate from the drop down menu. 4800, 9600, 19200 and 38400.
c) Parity
Select preferred parity from the drop down menu: None (0), Odd (1) or Even (2).
d) Stop Bits
Select preferred Stop Bits from the drop down menu; 1 or 2.
3.2 Data Log Options (File)
See Figure 7.
a) Time between successive readings (1-3600 sec). Default is 10 sec.
Select the time lag preferred between each successful reading using the arrow keys.
b) Length of Time to Capture Data. Default is 0 min. (0= indefinitely, units = min)
Select the total length of time preferred to capture data using the arrow keys.
The data capture will automatically stop upon reaching the set amount of time.
Maximum default time is 10080 minutes (1 week).
Figure 7: Data Log Options
Click OK to exit and save settings