Airedale EcoChill 6kW - 46kW - Manual (Page 4)

4
EcoChill Chiller
Technical Manual 7300221 V1.1.0_02/2013
Health and Safety
IMPORTANT
The information contained in this manual is critical to the correct operation and maintenance of the unit and should be read
by all persons responsible for the installation, commissioning and maintenance of this Airedale unit.
Safety
The equipment has been designed and manufactured to meet international safety standards but, like any mechanical/
electrical equipment, care must be taken if you are to obtain the best results.
CAUTION
Installation, service and maintenance of Airedale equipment should only be carried out by technically trained competent
personnel.
CAUTION
When working with any air conditioning units ensure that the electrical isolator is switched off prior to servicing or repair work
and that there is no power to any part of the equipment.
Also ensure that there are no other power feeds to the unit such as fire alarm circuits, BMS circuits etc.
Electrical installation commissioning and maintenance work on this equipment should be undertaken by competent and
trained personnel in accordance with local relevant standards and codes of practice.
The refrigerant used in this range of products is classified under the COSHH regulations as an irritant, with set Workplace
Exposure Levels (WEL) for consideration if this plant is installed in confined or poorly ventilated areas.
A full hazard data sheet in accordance with COSHH regulations is available should this be required.
Protective Personal Equipment
Airedale recommends that personal protective equipment is used whilst installing, maintaining and commissioning
equipment.
−
Refrigerant Warning
−The Airedale EcoChill uses R410A refrigerant which requires careful attention to proper storage and handling procedures.
Use on manifold gauge sets designed for use with R410A refrigerant. Use only refrigerant recovery units and cylinders
designed for high pressure refrigerants.
The refrigerant must be stored in a clean, dry area away from sunlight. The refrigerant must never be stored above 50°C.
Manual Handling
Some operations when servicing or maintaining the unit may require additional assistance with regard to manual handling.
This requirement is down to the discretion of the engineer. Remember do not perform a lift that exceeds your ability.