Badger Meter GALAXY - Manual (Page 12)

5 . Position the endpoint under the pit lid, as shown, lining up the holes drilled in the pit lid with the endpoint mounting
clip holes .
Figure 18: Endpoint on under side of pit lid
6 . Attach the endpoint to the underside of the pit lid using 1/4-20 thread screws . Tighten the screws to a maximum of 22
inch-pounds .
Figure 19: Attach endpoint under pit lid
The endpoint mounting is complete .
7 . To complete installation, install the encoder onto the water meter and secure it with the provided TORX seal screw .
NOTE: N GALAXY endpoints cannot be installed under a metal pit lid .
1/4-20 thread screws
GALAXY® Fixed Network Water Endpoint
Page 12 June 2014