Badger Meter 3100 Series Flow Monitor - Manual (Page 20)

Page 20
2-12
Series 3000 Flow Monitor
5. Configure this port with 38400 baud, 8 data bits, 1 stop bit, no parity and no flow control.
6. When connected, a ">" symbol will appear in the upper left corner of the main HyperTerminal display screen. Press the
“Enter Key”. Both the Rx and Tx LEDs on the front of the Series 3000 should flash once, and the “Badger Meter DIC …
Software Version…” text message should appear.
The Series 3000 Flow Monitor is now communicating, ready to take commands from the list below.