Innotech Maxim - Manual (Page 16)

MAXIM Installation Instructions
Page 16 © Mass Electronics Pty Ltd 2011 Edition 2.0 dated 20/11/2013
2-1 Overview
This section of the manual provides information to allow for the mechanical installation of the MAXIM
Series controllers. Physical descriptions and dimension diagrams are provided for all controllers,
followed by general installation instructions that include installing the MAXIM Series controllers on
industry standard DIN rail.
Innotech recognises that the installation examples described in this manual may not suit the
requirements of all customers. However this document should serve as a guide for all installations,
regardless of whether your particular installation is similar to that of provided examples. In all cases,
installation personnel should familiarise themselves with the information contained in this section.
Digital
Controller
Power
Transformer
General Power
Outlet (GPO)
Auxillary
Power
Transformer
Terminal Strip
PRIM
AR
Y NE
TW
ORK
PRIMARY NETWORK
MAXIM II
MAXIM III
MM01
IG01 VM01 MM02 UM01
UM01 MM02 VM01 IG01
Figure 2-1: Typical Enclosure Installation
It is highly recommended that the MAXIM Series controllers be installed and mounted in a steel enclosure to
minimise the effects of Electro Magnetic Interference (EMI), as illustrated in Figure 2-1 below.
NOTE