Milestone XProtect Express 2014 - Manual (Page 79)

Milestone XProtect ® Express 2014 Administrator's Manual
www.milestonesys.com 79 Advanced configuration
Record All Frames on
Allows you to make exceptions if you have selected to record
keyframes only.

Motion Detection: Select this to record all frames when
motion is detected. Two seconds after the last motion (see
"Motion detection & exclude regions" on page 94) is
detected, the camera will return to recording keyframes
only.

Event: Select this to record all frames when an event
occurs and until another event occurs. Requires that events
(see "Overview of events and output" on page 104) have
been defined, and that you select start and stop events in
the neighboring columns.
Use the Configure events list, located below the other
fields to define events that suit your needs.

Motion Detection & Event: Select this to record all frames
when motion is detected, or when an event occurs and until
another event occurs. Remember to select start and stop
events in the neighboring columns.

Schedule only: Select this to record all frames according to
the camera's speedup schedule (see "Speedup" on page
129) only.
Start Event
Use when recording on Event or Motion Detection & Event.
Select required start event. The camera will begin recording all
frames when the start event occurs.
Stop Event
Select required stop event. The camera will again only recording
keyframes when the stop event occurs.
Audio selection
When you configure video and recording (see "About video and recording configuration" on page 63),
you can specify certain properties for many cameras in one go. Either in order to speed up things, or
because the properties in question are shared by all cameras rather than being specific to individual
cameras. With a default microphone and/or speaker selected for a camera, audio from the microphone
and/or speaker is automatically used when you view video from the camera. Note that all of the
properties can also be specified individually for each camera.
Properties available in all XProtect software versions:
Name Description
Template
The template can help you configure similar properties quickly. Say
you have 20 cameras and you want to change the recording path,
archiving path, and retention time for all of them. Instead of having
to enter the same three pieces of information 20 times, you can
simply enter them once in the template, and then apply the template
to the 20 cameras with only two clicks.