Sterlco A3 Blender Control and Data Acquisition Software - Manual (Page 53)

Page Number 53
Verify Action Options
These options enable or disable the “Are you sure…” prompts after certain
operations.
Hard Drive Options
This option allows the user to configure the minimum allowed hard drive
space to allow saving. The minimum value that can be entered here is
2000 MB (2 GB).
Security Options
These options enable or disable password protection on certain operations.
Once password protection is enabled the operator must enter in the user
password in order to perform the operation. You will be asked to enter in
the master password in order to access this tab. The default Master
Password is “3145348” and the default User Password is “5413”. These
can be modified to whatever you desire. If you change either password
you will be asked to verify the change before the change will be allowed.