Sterlco A3 Blender Control and Data Acquisition Software - Manual (Page 71)

Page Number 71
Configuring a ACS Allen Bradley Batch Blender Device
When selecting a newer AB OS/OA device you will also need to enter in
the IP Address for the blender. This IP is a fixed IP and must be unique for
every device that resides on the same LAN (Ethernet Network). Some
examples are: “192.168.0.10”, “192.168.0.1”, “192.168.0.2”, etc. You will
also need to program the blender with the same IP address. Below is a the
blender’s IP address and Subnet Mask under “Network Setup”:
Step 1: touch the AEC icon and enter your password
Step 2: touch “Network Setup”
Step 3: set appropriately