Sterlco A3 Blender Control and Data Acquisition Software User Manual
Page 72
Advertising
Page Number 72
You will also need to set the SUBNET MASK for the blender. This needs
to be set to “255.255.255.0”. Once configured you will need to make sure
you have connected the Ethernet Module and Cable (see “Networking
instructions for the newer AB OS/OA Blender” for details). Finally, touch
“Send Ethernet Config to Module” and monitor the Ethernet module on the
blender. After about 30 seconds the fault light should stay off and the LINK
light should be green:
Advertising