ARM Cortex R4F - Manual (Page 175)

Events and Performance Monitor
ARM DDI 0363E Copyright © 2009 ARM Limited. All rights reserved. 6-11
ID013010 Non-Confidential, Unrestricted Access
Figure 6-4 FLAG Register format
Table 6-5 shows how the bit values correspond with the FLAG Register.
To access the FLAG Register, read or write CP15 with:
MRC p15, 0, <Rd>, c9, c12, 3 ; Read FLAG Register
MCR p15, 0, <Rd>, c9, c12, 3 ; Write FLAG Register
If an overflow flag is set to 1 in the FLAG register it remains set until one of the following
happens:
•
writing 1 to the flag bit in the FLAG Register clears the flag
• the processor is reset.
The following operations do not clear the overflow flags:
•
disabling the overflowed counter in the CNTENC Register
• disabling all counters in the PMNC Register
• resetting the overflowed counter using the PMNC Register.
6.3.5 c9, Software Increment Register
The Software INCRement (SWINCR) Register increments the count of a Performance Monitor
Count Register.
The SWINCR Register is:
• A write-only register that Reads-As-Zero
• Always accessible in Privileged mode. The USEREN Register determine accessibility in
User mode, see c9, User Enable Register on page 6-15.
Caution
You must only use the SWINCR Register to increment performance monitor count registers
when the counter event is set to
0x00 , software count, in the Event Select Register, see c9, Event
Selection Register on page 6-13.
C
31 3 2 1 0
Reserved
P2
P1
P0
Performance monitor counters
overflow flags
Cycle count overflow
Table 6-5 Overflow Flag Status Register bit functions
Bits Field Function
[31] Cycle counter overflow Cycle counter overflow flag:
0 = disable
1 = enable.
[30:3] Reserved UNP on reads, SBZP on writes
[2] P2 Counter 2 overflow flag
[1] P1 Counter 1 overflow flag
[0] P0 Counter 0 overflow flag