Caution – Brother SQ9185 User Manual

Page 22

Advertising
background image

20

KNOWING YOUR SEWING MACHINE ———————————————————————————————————————————————————————————————————————————————————

l

Slide the sewing speed controller to the right
(to set the speed to fast). (For models
equipped with the sewing speed controller.)

a Sewing speed controller

m

Press the foot controller or press

(start/

stop button) (for models equipped with the
start/stop button) to start.

n

When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller or press

(start/stop button) (for

models equipped with the start/stop button).

o

Cut the thread, slide the bobbin winder shaft
to the left and remove the bobbin.

p

Slide the sewing speed controller back to its
original position (for models equipped with
the sewing speed controller).

Memo

● When the sewing machine is started or the

handwheel is turned after winding the
thread around the bobbin, the machine will
make a clicking sound; this is not a
malfunction.

● The needle bar does not move when you

slide the bobbin winding shaft to the right.

For models equipped with the fast bobbin

winding system

a

Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin.

a Notch
b Bobbin winder shaft spring

b

Slide the bobbin winder shaft to the right.

c

Follow steps

a

through

g

of the procedure

in “Winding the bobbin” to pass the thread
around the pre-tension disk (page 17).

d

While holding the thread that wraps around the
pre-tension disk with your left hand, use your
right hand to wind the free end of the thread
clockwise around the bobbin five or six times.

Not winding the bobbin properly may cause

the thread tension to loosen, and may break
the needle.

a Wound evenly
b Wound poorly

CAUTION

1

2

Advertising