Starting to sew – Brother SQ9185 User Manual

Page 43

Advertising
background image

41

2

————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————

Starting to sew

a

Raise the needle by turning the handwheel
toward you (counterclockwise) so that the mark
on the wheel points up. (With models equipped
with

(needle position button), raise the

needle by pressing

once or twice.)

b

Raise the presser foot lever.

a Presser foot lever

c

Place the fabric under the presser foot, pass
the thread under the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.

a 5 cm (2 inches)

d

While holding the end of the thread and the
fabric with your left hand, turn the handwheel
toward you (counterclockwise) with your
right hand to lower the needle to the starting
point of the stitching.

e

Lower the presser foot lever.

a Presser foot lever

f

On models equipped with a sewing speed
controller, slide the sewing speed controller
to the left or right to adjust the sewing speed.
Refer to “Sewing speed controller (for models
equipped with the start/stop button)”
(page 15).

a Sewing speed controller

g

Slowly press down on the foot controller.
(With models equipped with

(start/stop

button), if the foot controller is not connected,
press

once.)

aStart/stop button

X

The machine starts sewing.

a Mark

b Needle position button

or

or

Advertising