Brother MFC-J410W - Manual (Page 37)

Configuring your machine for a wireless network
30
3
c
Press a or b to choose Network.
Press OK.
d
For DCP-J715W, MFC-J615W and MFC-J630W
Press a or b to choose WLAN.
Press OK.
e Press a or b to choose Setup Wizard.
Press OK.
f When Enable WLAN? or Network I/F switched to Wireless. is displayed, press OK to
accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
g
The machine will search for your network and display a list of available SSIDs.
Choose <New SSID> using a or b.
Press OK.
h Enter the SSID name. (For information how to enter text, see Entering Text on page 112.)
Press OK.
i Using a or b, choose Ad-hoc or Infrastructure when instructed.
Press OK.
Do one of the following:
If you chose Ad-hoc, go to step k.
If you chose Infrastructure, go to step j.
j Choose the Authentication method using a or b, and press OK.
Do one of the following:
If you chose Open System, go to step k.
If you chose Shared Key, go to step l.
If you chose WPA/WPA2-PSK, go to step m.
k Choose the Encryption type None or WEP using a or b, and press OK.
Do one of the following:
If you chose None, go to step o.
If you chose WEP, go to step l.
l
Enter the WEP key you wrote down in step a on page 29. Press OK. Go to step o. (For information
how to enter text, see Entering Text on page 112.)
m
Choose the Encryption type, TKIP or AES using a or b. Press OK. Go to step n.
n
Enter the WPA key you wrote down in step a on page 29 and press OK. Go to step o. (For information
how to enter text, see Entering Text on page 112.)
o
To apply the settings, choose Yes. To cancel, choose No.
Do one of the following:
If you chose Yes, go to step p.
If you chose No, go back to step g.