Brother MFC-J410W - Manual (Page 58)

Wireless configuration using the Brother installer application
51
4
d
Choose Yes, my Access Point supports WPS or AOSS and I want to use them. and click Next.
e
Read the Important Notice. Check the box after you confirm the wireless setting is enabled, and then
click Next.
f
Press Menu, a or b to choose Network and press OK.
(For DCP-J715W, MFC-J615W and MFC-J630W) Press a or b to choose WLAN and then press OK.
Press a or b to choose WPS/AOSS and press OK.
Note
If your wireless access point supports Wi-Fi Protected Setup (PIN Method) and you want to configure your
machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi
Protected Setup on page 34.
g The machine searches for an access point that supports Wi-Fi Protected Setup or AOSS™ for
2 minutes.
h Put your access point in the Wi-Fi Protected Setup mode or AOSS™ mode, depending on what is
supported by your access point. Please refer to the instruction manual that came with your access point.