Brother MFC-J410W User Manual
Page 67
Wireless configuration using the Brother installer application
60
4
2
Click Network Connections icon.
3
Choose and right click Wireless Network Connection. Click View Available Wireless Networks.
4
You can see the Brother wireless machine in the list. Choose SETUP and click Connect.
5
Check the Wireless Network Connection status. It may take a few minutes to change from 0.0.0.0.
to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and 254).
• Macintosh:
You can temporarily change the wireless settings on your computer, following the steps below:
1
Click the AirPort status icon in the menu bar.
2
Select SETUP from the pop-up menu.
3
Your wireless network is connected successfully.
j
Choose the machine you wish to configure, and click Next. If the list is blank, check if the machine is
powered on, and then click Refresh.
Note
The default Node name is “BRWxxxxxxxxxxxx” (where “xxxxxxxxxxxx” is your MAC Address / Ethernet
Address).