Brother HL-L9200CDWT - Manual (Page 120)

General Information
113
3
Ecology features
3
Toner Save
3
Save toner by using this feature. When you set Toner Save to On, print appears lighter. The default setting is
Off.
a Press .
b Press General Setup > Ecology > Toner Save.
c Press On or Off.
d Press .
NOTE
If your machine has been set to Quiet mode On, you cannot set Toner Save to On.
Sleep Time
3
The Sleep mode setting can reduce power consumption. When the machine is in Sleep mode (Power Save
mode) it acts as though it were turned off. The machine will wake up and start printing when it receives a print
job.
Choose how long the machine must be idle before it goes into Sleep mode. When the machine receives a
print file or document, the timer will be reset. The default setting is 3 minutes. While the machine is in Sleep
mode the Touchscreen's backlight turns off.
a
Press .
b Press General Setup > Ecology > Sleep Time.
c
Enter the length of time (0-50 minutes) the machine will remain idle before entering Sleep mode, and
then press OK.
d Press .
Deep Sleep mode
3
If the machine is in Sleep mode and does not receive any jobs for a certain length of time, the machine will
go into Deep Sleep mode and the Touchscreen's backlight turns off and
blinks. Deep Sleep mode uses
less power than Sleep mode. The machine will wake up, when the machine receives a print job.