Canon EOS C300 - Manual (Page 41)

41
Error Messages
Wi-Fi connection terminated
An error occurred on the access point or the computer or other Wi-Fi enabled
device.
X
Check the Wi-Fi enabled device and access point and try connecting again.
The Wi-Fi signal became too weak and the wireless connection was lost.
X
Wait a moment or turn off other devices in the area that may be interfering with the Wi-Fi
signal and then try connecting again.
Wi-Fi error. Incorrect encryption key.
When the encryption method was set to [WEP], the WEP index key (encryption key)
or its length (number of characters) is incorrect.
X
When entering ASCII characters, enter 5 characters (64-bit encoding) or 13 characters
(128-bit encoding). When entering hexadecimal characters, enter 10 characters (64-bit
encoding) or 26 characters (128-bit encoding).
Wireless communication cannot be used
The WFT-E6 Wireless File Transmitter has malfunctioned.
X Consult a Canon Service Center (listed on the back cover of the camcorder’s instruction
manual).
Wireless communication cannot be used WFT error
The channel specified in the [LAN Setup] settings of the network configuration
selected cannot be used in accordance with the restrictions on countries/regions
of use of the attached WFT-E6 Wireless File Transmitter model.
X
Change the [LAN Setup] settings (A 35). For details see Areas of Use and Restrictions
(supplied with the transmitter).
Wireless communication cannot be used while the wireless microphone is attached
The transmitter cannot be used while an optional WM-V1 Wireless Microphone is
attached to the camcorder.
X
Disconnect the WM-V1 from the camcorder and turn it off.
Wireless communication is not working correctly
There’s a hardware problem with the camcorder’s Wi-Fi-related circuitry.
X
Try turning the camcorder off and the on again. If the problem persists, consult a Canon
Service Center.
COP
Y