Canon XF305 - Manual (Page 103)

103
Recording 3
Special Recording Modes
Available Intervals*
* In the camcorder’s menu, seconds are indicated by [sec] and minutes are
indicated by [min].
Activating Interval Recording Mode and Recording
1 Open the [Special Rec] submenu.
[J Other Functions] [Special Rec]
2 Select [Interval Rec] and then press SET.
• [INT STBY] appears at the top of the screen (with [INT] flashing).
3 Press the START/STOP button to begin recording.
• The camcorder automatically records the set number of frames at
the set interval.
• The tally lamps illuminate.
• [INT STBY] changes to [N INT REC] while recording frames and
[N INT STBY] while between intervals.
4 Press the START/STOP button again to stop recording.
• All of the recorded frames are joined together into one clip.
• The tally lamps go out and [INT STBY] appears at the top of the
screen (with [INT] flashing).
NOTES
• You can use only one special recording mode at a time.
• While recording, you cannot change the interval or number of frames.
• Some frames at the point the recording was stopped may be recorded
and added to the end of the clip.
• Interval recording mode will be deactivated if the special recording
mode is changed or turned off. It will be deactivated also if you change
the [J Other Functions]
[Bit Rate/Resolution] or [Frame Rate]
setting.
• The time code advances by the number of frames recorded. If the
running mode of the time code (0 82) is set to [Free Run] or the time
code is input from an external source (b only), the running mode
will switch to [Rec Run] during special recording mode. When special
recording mode is deactivated, the running mode will return to its
previous setting.
• b During special recording mode, the time code signal will not
be output from the TIME CODE terminal or HD/SD SDI terminal.
1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec 9 sec
10 sec 15 sec 20 sec 30 sec 40 sec 50 sec 1 min 2 min 3 min
4 min 5 min 6 min 7 min 8 min 9 min 10 min
[J Other Functions]
[ Special Rec]
[Off]
COP
Y