Canon LV-7292S - Manual (Page 52)

52
Setting
Standby mode
This function can set the electric power when
the projector is standing by.
Serial ...... Does not restrict functionality even
in standby mode.
Eco ......... Restricts some functions in
standby mode to reduce power
consumption.
 Note:
• When selecting Serial, the cooling fans may be
running depending on the temperature inside
the projector even if the projector is turned off.
• When Eco is selected and the projector is in
Standby mode, the communication of RS-232C
serial port is not available.
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
Count up ....... The P-timer display 000:00
appears on the screen and the
count up starts ( 000:00-180:00)
Count down .. The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer ............. Use the Point ▲▼ buttons to set
the Timer ( 1-180 Min). Timer is
available in Count down only.
Factory default velue is 10 Min.
Start ............... It executes the count up or count
down function. Press the OK
button at Start and the indication
changes into Stop. To stop
Count up or Count down, press
the OK button at Stop on the
screen menu, then the indication
changes into Restart. Press the
OK button at Restart to resume
Count up or Count down.
Reset ............. Reset the P-timer values.
Press the OK button at Reset to
return to the following value;
Count up ... "000:00"
Count down ... Timer that you
set
Exit ................ To exit the P-timer operation.
P-TIMER
P-timer display
Stop or Cancel the P-timer via Remote control unit
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
P-timer
X: disabled O: enabled
Eco Serial
Serial command X O
Direct power on O O