Canon PowerShot ELPH 115 IS User Manual
Page 100
100
1
2
3
4
5
6
7
8
9
Cover
Preliminary Notes and
Legal Information
Contents:
Basic Operations
Advanced Guide
Camera Basics
Smart Auto
Mode
Other Shooting
Modes
P Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Basic Guide
Playback Mode
Cover
Advanced Guide
6
Wi-Fi Functions
•
The following Windows settings are configured when you run the utility in step 2.
-
Turn on media streaming.
This will enable the camera to find the computer to access via Wi-Fi.
-
Turn on network discovery.
This will enable the computer to find the camera.
-
Turn on ICMP (Internet Control Message Protocol).
This allows you to check the network connection status.
-
Enable Universal Plug & Play (UPnP).
This will enable network devices to detect each other automatically.
•
Some security software may prevent you from completing the settings as
described here. Check the settings of your security software.
Adding a Computer
Add a computer to your list of devices to connect to via Wi-Fi.
Follow these instructions when using a Wi-Fi Protected Setup (WPS)
compatible access point to establish a push-button connection.
If your access point is not WPS-compatible, establish a connection as
described in “Connecting to Access Points in the List” (
•
WPS makes it easy to complete settings when connecting devices over Wi-Fi.
You can use either Push Button Configuration Method or PIN Method for
settings on a WPS supported device.
•
Refer to the user guide provided with your access point to check if it supports
WPS.
•
Be sure to also read the user guide included with your access point.
1
Access the Wi-Fi menu.
z
z
Press the <
o> button.
2
Choose a computer.
z
z
Press the <
o><p><q><r> buttons to
choose [ ], and then press the <
m>
button.
3
Choose [Add a Device].
z
z
Press the <
o><p> buttons to choose
[Add a Device], and then press the <
m>
button.
X
X
A list of detected access points will be
displayed in the [Select Network] screen.
4
Choose [WPS Connection].
z
z
Press the <
o><p> buttons to choose
[WPS Connection], and then press the
<
m> button.
5
Choose [PBC Method].
z
z
Press the <
o><p> buttons to choose
[PBC Method], and then press the <
m>
button.