Troubleshooting-1, Initial operation, Temperature – Electrolux EP19WI30LS User Manual
Page 26
24
Troubleshooting-1
Initial Operation
Unit does not attempt to ignite
when water is running.
r$IFDLGPSSFWFSTFEQMVNCJOHPSDSPTTFEQJQFT
r$IFDLUIFXBUFSESBJOWBMWFàMUFS
p.23)
Unit attempts to ignite but fails.
Temperature
Hot water is not available
when a fixture is opened.
r"SFUIFHBTBOEXBUFSTVQQMZWBMWFTGVMMZPQFO
r*TUIFXBUFSTVQQMZDVUPGG
r*TUIFIPUXBUFSàYUVSFTVGàDJFOUMZPQFO
r*TUIFHBTCFJOHDVUPGGCZUIFHBTNFUFS
$BOPUIFSHBTEFWJDFTTVDIBTTUPWFTCFVTFE
r 'PS-1 *TUIFSFFOPVHIHBTJOUIFUBOL
$BOPUIFSHBTEFWJDFTTVDIBTTUPWFTCFVTFE
r*TUIFXBUFSESBJOWBMWFàMUFSDMPHHFE
p.23)
r*TUIFQPXFSCVUUPOUVSOFEPO
r"SFUIFHBTBOEXBUFSTVQQMZWBMWFTGVMMZPQFO
r*TUIFXBUFSUFNQFSBUVSFTFUUJOHBQQSPQSJBUF
(
p.12 and p.13)
r*GUIFXBUFSTVQQMZUFNQFSBUVSFJTIJHI JUJTQPTTJCMFGPSUIF
temperature to be higher than the temperature set on the
remote controller.
r*GPOMZBTNBMMBNPVOUPGIPUXBUFSJTEFNBOEFE JU
is possible for the temperature to be higher than the
temperature set on the remote controller.
The water is too hot.
r)BWFZPVBMMPXFEFOPVHIUJNFGPSUIFDPMEXBUFSJOUIF
QJQFTUPESBJOPVU
Water takes time to become hot
when turning the hot water fixture.
No water is available when
a fixture is opened.
r*TUIFXBUFSTVQQMZDVUPGG
r*TUIFIFBUFSGSP[FO
The hot water is not the correct
temperature.
r*TUIFIPUXBUFSàYUVSFTVGàDJFOUMZPQFO
r3FTFUVOJUBOEUSZBHBJO5IFSFNBZCFBJSJOUIFHBTMJOF
r)BWFBQSPGFTTJPOBMDIFDLUIFHBTTVQQMZQSFTTVSF
r"SFUIFHBTBOEXBUFSTVQQMZWBMWFTGVMMZPQFO
r*TUIFXBUFSUFNQFSBUVSFTFUUJOHBQQSPQSJBUF
(
p.12 and p.13)
r*GUIFBNPVOUPGIPUXBUFSSFRVJSFEJTWFSZIJHI JU
is possible for the temperature to be lower than the
temperature set on the remote controller.
Decrease the amount of hot water passing through the unit
and the temperature should stabilize.
The water is not hot enough.