Amount of hot water – Electrolux EP19WI30LS User Manual
Page 27
25
The water is cold when only a
single fixture is open.
r5IFVOJUXJMMOPUIFBUUIFXBUFSJGUIFáPXSBUFJTMFTTUIBO
0.5 gallons (2L) per minute.
Open the fixture more or open other fixtures so that a
greater flow passes through the unit, and the unit should
begin heating again.
Amount of Hot Water
The amount of hot water at a
certain fixture is not constant.
rWhen hot water is demanded at other fixtures, the amount
available may be reduced. The maximum flow available from
UIF&/8*-4
&18*-4JT(1. -NJO
at a
45°F (25°C) temperature rise. The maximum flow available
GSPNUIF&/8*-4
&18*-4JT(1. -NJO
BU
a 45°F (25°C) temperature rise.
r1SFTTVSFáVDUVBUJPOTBOEPUIFSQMVNCJOHDPOEJUJPOTDBO
cause the temperature and pressure at a fixture to be
unstable, but it should stabilize after a short time.
r5IFSF BSF TPNF UZQFT PG IPU XBUFS UBQT UIBU EJTDIBSHFT
large volumes of hot water at first but stabilize after time.
r5PLFFQUIFUFNQFSBUVSFTUBCMF UIFIFBUFSMJNJUTUIF
amount of water that can flow through it to a small amount
initially, but the amount increases over time.
The amount of hot water in the tub
JTMFTTNPSFUIBOUIFTFUBNPVOU
r8IFOIPUXBUFSJTVTFEGPSPUIFSàYUVSFTXIJMFàMMJOHUIF
bath tub, the tub will not fill as much.
rIf there is water in the tub already, or when filling is stopped
and restarted, the tub will fill more.
The flow meter alarm does not
sound even when filled to the set
amount.
r5IFáPXNFUFSBMBSNJTTFUUPTPVOEXIFOIPUXBUFS
is continuously discharged for the set volume of water.
If mixing valves are used, or if cold water is mixed with hot
water at the fixture, the tub will fill more than the setting
of the flow meter alarm.
Amount of hot water available
has decreased over time.
Fluctuations in hot water
temperatures.
r4FUXBUFSUFNQFSBUVSFBU°F to 120°F or 48°C (118°F) to
50°C (122°F). This will allow you to use a higher flow of hot
water thus meeting the minimum flow requirement of 0.5
(1. -NJO
r$MFBOUIFXBUFSàMUFSPGBOZEFCSJT (
p.23)
Setting temperature cannot rise.
r*TUIFNBYJNVNUFNQFSBUVSFTFUUJOHBQQSPQSJBUF (
p.17)
r*TUIFXBUFSàMUFSDMPHHFE
p.23)
r*GUIFTVQQMZXBUFSJTIBSEBOEIBTOPUCFFOUSFBUFE
scale can build-up in the water heater and decrease
the maximum amount of hot water available. Scale can
be removed from the water heater by flushing the unit
periodically. To prevent scale from forming in the water
heater, a water softener or scale inhibitor is recommended.