Acer Altos R310 User Manual

Page 36

Advertising
background image

3 Getting Started

26

3Ch

If CMOS is valid, load chipset registers with
values from CMOS, otherwise load defaults
and display Setup prompt. If Auto Configu-
ration is enabled, always load the chipset
registers with the Setup defaults.

3Dh

Load alternate registers with CMOS values.
Register-table pointers are in the altreg-
table segment.

41h

Initialize extended memory for RomPilot.

42h

Initialize interrupt vectors 0 thru 77h to the
BIOS general interrupt handler.

45h

Initialize all motherboard devices.

46h

2-1-2-3

Verify the ROM copyright notice

47h

Initialize support for I2O by initializing glo-
bal variables used by the I2O code. Pause
POST table processing if a CMOS bit is set
(for debugging).

48h

Verify that the equipment specified in the
CMOS matches the hardware currently
installed. If the monitor type is set to 00
then a video ROM must exist. If the monitor
type is 1 or 2 set the video switch to CGA. If
monitor type 3, set the video switch to
mono. Also specify in the equipment byte
that disk drives are installed. Set appropri-
ate status bits in CMOS or the BDA if config-
uration errors are found.

Checkpoint
Code

Beep Code

Description

BB!S421!.!FO/cppl!!Qbhf!37!!Xfeoftebz-!Nbsdi!35-!3115!!6;1:!QN

Advertising