AT&T 9050 - Manual (Page 15)

13
ANSWERING SYSTEM SETUP
Turning the System ON/OFF
Press O to turn the answering system on or off. The ON/OFF light is on
when the system is on.
Volume
Press + to increase volume when listening to messages. Press -
to decrease volume.
Setting the Clock
You’ll need to set the clock so it can record the day and time that each message
is received.
1 Press and release U until you hear “Set day and time.”
2 Press and release S until you hear the correct day of the week.
3 Press C to confirm your selection. The system announces the hour.
4 Press and release S until you hear the correct hour.
5 Press and release C to confirm your selection. The system
announces the minutes.
6 Press and release S until you hear the correct minutes.
7 Press and release C to confirm your selection. The system
announces the current day and time.
8 Press and release U to set up another feature
— OR —
Press and release
Y to exit.
Announcement Options
Normal Announce Mode
Before using this answering system, you should record an announcement (up
to 90 seconds long) that callers will hear when the system answers a call. For
example:
“Hello. You’ve reached Meadowlark Nursery. We are unable to answer
your call at this time. Please leave a message after the tone.”
If you choose not to record an announcement, the system answers with a
prerecorded announcement: “Hello. I’m unable to answer your call right
now. Please leave your name, number and a message after the tone.”
9050_book.1AT&T 8/12/98, 4:14 PM 13