AT&T 9050 - Manual (Page 18)

16
ANSWERING SYSTEM SETUP
NOTE: You may stop the Audible Message Alert beep by pressing any button
(
except G) on the base. When new messages are received, the
Audible Message Alert is activated again.
Remote Access Code
The Remote Access Code allows you to access features and functions of the
answering system from a touch tone phone. The Remote Access Code is preset
to 19, but you can change it to any two-digit number following the steps below.
1 Press and release U until you hear “Set security code.”
2 Press and release S to hear the current Remote Access Code.
3 Press and release S to increase the code by one
— OR —
Press and hold
S to increase the code by ten. The Message Window
displays the Remote Access Code as you change it.
4 Press and release C to confirm your selection. The system
announces your new Remote Access Code.
5 Press and release U to set up another feature
— OR —
Press and release
Y to exit.
Base Ringer Setting
1 Press and release U until you hear “Set base ringer.”
2 Press and release S. The Message Window briefly displays the
current setting.
3 Press and release S until the Message Window displays your
selection — ON (on) or OF (off).
4 Press and release C to confirm your selection. The system
announces your selection.
5 Press and release U to set up another feature
— OR —
Press and release
Y to exit.
NOTE: The Base Ringer Setting does not affect the handset ringer.
9050_book.1AT&T 8/12/98, 4:15 PM 16