AT&T 9050 User Manual
Page 28
26
IN CASE OF DIFFICULTY
If the system does not respond to remote commands
from a touch tone phone:
•
Make sure you are calling from a touch tone phone. When you dial a number,
you should hear tones. If you hear clicks instead, the phone is not a touch
tone telephone.
•
The answering system may not detect the Remote Access Code while your
announcement is playing. Try waiting until the announcement is over before
entering the code.
•
Be sure to press #, then enter your Remote Access Code within two
seconds. Make sure you enter your Remote Access Code correctly.
•
There may be noise or interference on the phone line you are using. Press
keys firmly.
If your outgoing announcement isn’t clear:
•
When you record your announcement, make sure you speak in a normal
tone of voice, about nine inches from the base.
•
Make sure there is no “background” noise while you are recording.
9050_book.1AT&T
8/12/98, 4:15 PM
26