APC Network Management Card none - Manual (Page 35)

Network Management Card User’s Guide 28
Device Manager Menus
UPS Status
FRQWLQXHG
Utility Voltage
Status The following table uses footnotes to indicate which utility-voltage fields
are shared by which
UPS models (if no footnote is used, all UPS models
report that value).
Note: A 3-phase UPS (Silcon 3 Phase or Silcon DP300E series UPS)
identifies the values for all three phases.
&RQWLQXHG RQ QH[W SDJH
6WDWXV )LHOG 'HILQLWLRQ
Bypass Input
Voltage
1
Identifies the AC voltage (VAC) used when the UPS is in bypass
mode.
Input Current 1
Identifies how much current is being supplied by the input
voltage.
Input Frequency
2
Identifies the input voltage’s frequency, in Hertz (Hz).
Note: In the Control Console for Smart-UPS or Matrix-UPS,
the
Operating Frequency field reports the frequency
value shared by the input and output voltages.
Input Voltage Identifies the AC voltage (VAC) being input to the UPS .
Minimum Line
Voltage Identifies the lowest AC voltage input to the UPS during the
previous minute of operation.
Maximum Line
Voltage Identifies the highest AC voltage input to the UPS during the
previous minute of operation.
1
Symmetra 3 Phase and Silcon DP300E series UPS models
2 Smart-UPS, Matrix-UPS, or Symmetra UPS models