6 connecting to the network – Asante Technologies 35160 User Manual
Page 15
15
Important: If the power does not come on, check the next section to ensure you are using the correct
cabling.
2.6 Connecting to the Network
The switch may be connected to an Ethernet network with the unit powered on or off.
Use the following
procedure to make your network connections:
1. Connect your network devices to the switch, following the cable guidelines outlined below.
2. After the unit is connected to the network, it can be configured for management capabilities (see
the following chapters for information on configuration).
2.6.1 10/100/1000BaseT Ports Cabling Procedures
The 10/100/1000 ports on the switch allow for the connection of 10BaseT, 100BaseTX, or 1000BaseT
network devices. The ports are compatible with IEEE 802.3 and 802.3u standards.
Important: The switch must be located within 100 meters of its attached 10BaseT or 100BaseTX devices.
Use the following guidelines to determine the cabling requirements for your network devices:
•
Connecting to Network Station: Category 5 UTP (Unshielded Twisted-
Pair) straight-through cable (100 meters maximum) with RJ-45 connectors
•
Connecting to Repeater/Hub/Switch’s Uplink port: Category 5, UTP
straight-through cable (100 meters maximum) with RJ-45 connectors
Note: There aren’t specific uplink ports on these switches. All 10/100 ports on
these switches are auto-sensing MDI/MDI-X. This advanced feature means that the
10/100 ports will automatically determine whether the device at the other end of the link is a hub, switch or
workstation, and adjust its signals accordingly.
Although 10/100BaseT requires only pins 1, 2, 3 and 6, Asanté strongly recommends cables with all 8 wires
connected as shown in Table 2-1 below.
1000BaseT requires that all four pairs (8 wires) be connected correctly, using Category 5 or better
Unshielded Twisted Pair (UTP) cable (to a distance of 100 meters). Table 2-1 shows the correct pairing of all
eight wires.
Pin Number
Pair Number & Wire Colors
1
2 White/Orange
2
2 Orange/White
3
3 White/ Green
4
1 Blue/White
5
1 White/Blue
6
3 Green/White
7
4 White/Brown
8
4 Brown/White
Table 2-2 Pin Numbers and Wire Colors