Asante Technologies 35160 - Manual (Page 34)

34
3.15 System Reset Configuration
The System Reset Configuration Menu allows you to reset the switch by performing a “warm” reboot. It also
allows you to schedule a reset up to 24 hours in advance.
IntraCore 35160-T System Reset Configuration Menu
Bank 1 Image Version/Date: 1.00C/Aug 22 2002 14:32:46
Bank 2 Image Version/Date: 1.00C/Aug 22 2002 14:32:46 (Running)
Reset Status: Stop
Reset Type: Normal
Reset Countdown: 1 sec.
Load Mode: Remote
Boot Bank: 2
<Cmd> <Description>
s Schedule Reset Time
c Cancel Reset
r Reset Switch
a Toggle Boot Bank
d Reset Switch to Factory Default
i Reset Switch to Factory Default except IP and Bootstrap
q Return to previous menu
Command>
3.15.1 Resetting the Switch
To reset the switch, use the following procedure:
1. Open the System Reset Menu by typing r in the Configuration Menu.
2. Type
r, d or i. Typing r resets the switch to its current configuration. Typing d resets switch to the
factory default. Typing i resets the switch to the factory default, but without affecting its IP and
Bootstrap configuration.
3. Type y to confirm the reset or type n to cancel the reset.
Note: During the scheduled reset operation, you can see the reset countdown decrement by
refreshing the screen.
3.15.2 Scheduling a System Reset
You can schedule the switch to automatically perform a reset from one second up to 24 hours (86,400
seconds) in advance.
To schedule a reset, use the following procedure:
1. Open the System Reset Menu by typing r in the Configuration Menu.
2. Type
s to schedule a reset time (within the specified range).
3. Enter the number of seconds the switch will wait before it automatically resets.
Important! The maximum number of seconds that can be entered is 86,400 (24 hours).
4. Press Enter. The switch will reset automatically after the number of seconds you specified.