Using tcp/ip over ethernet management port, Selecting an ethernet management port – HP ProLiant DL145 G3 Server User Manual
Page 13
Configuration 13
e.
Set Serial Port1 Address to 3F8/IRQ4.
o
On DL140 G3 servers, perform the following steps:
a.
Press the down arrow (↓)key to scroll to IO Device Configuration. Press the Enter key.
b.
Set Serial Port A to Enabled.
o
On DL145 G3 servers, perform the following steps:
a.
Press the down arrow (↓) key to scroll to the Console Redirection menu. Press the Enter key.
b.
Set Com Port Address to On-board COM A.
o
On ML150 G3 servers, perform the following steps:
a.
Press the down arrow (↓)key to scroll to IO Device Configuration. Press the Enter key.
b.
Set Serial Port 1 to Enabled.
c.
Set Serial Port1 Address to 3F8/IRQ4.
d.
Set Serial Port 2 to Enabled.
e.
Set Serial Port 2 Address to 2F8/IRQ3.
5.
Review the serial port settings, and make sure the settings match the serial port communications
software settings used to connect to LO100.
6.
Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit
Setup.
Using TCP/IP over Ethernet management port
You can configure LO100 LAN port access using two different Ethernet ports: the dedicated 10/100
LO100 management port or through a side-band connection using the server NIC. The side-band, shared,
or UMP options utilize one server Ethernet port for both server network traffic and LO100 network traffic
reducing the number of network cables that you must attach to the server.
Selecting an Ethernet management port
To select a shared Ethernet management port:
1.
Power on the server by pressing the Power On/Off button on the front panel.
2.
When POST displays the message, ROM-Based Setup, press the F10 key. If the server has an
administrator password configured, the system prompts you to enter the password. If the server does
not have a password configured, the main screen of the BIOS Setup Utility appears.
3.
Press the right arrow (→) key to navigate to the Advanced menu.
4.
Choose one of these options:
o
On ProLiant ML110 G4 servers:
a.
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
b.
Press the down arrow (↓) key to scroll to Share NIC Mode option. Press the Enter key to toggle
between Enabled and Disabled. Select Enabled.
o
On ProLiant ML115 G1 servers:
a.
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
b.
Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press the Enter key.