HP ProLiant DL145 G3 Server User Manual
Page 23
Using LO100 23
Properties
Verbs
cd
version
exit
show
help
The first line of information returned by the show command is the current context. In the example, /.
is the current context. Following the context is a list of subtargets (Targets) and properties (Properties)
applicable to the current context. The verbs section (Verbs) shows which commands are available in
this context.
You can also specify the show command with an explicit or implicit context and a specific property.
An explicit context is /map1/firmware and is not dependent on the current context. An implicit
context assumes that the context specified is a child of the current context. If the current context is
/map1, then a show firmware command displays the /map1/firmware data. If a property is not
specified, then all properties are shown.
•
The load command moves a binary image from a URL to the map. The load command takes a
binary image from a specific source location (specified as a URL) and places the image at the
specified target address. In a remote management processor implementation, the firmware
downloads a full image file using TFTP from the specified location and programs flash with the
image.
In a remote management processor implementation, /map1/firmware is a valid target.
The load command supports usage only with the following options.
o
-source <location>—This option must be specified.
o
(h)elp—This option appears on the command line. The command ignores all options and
properties except -output (for terse or verbose output). These options are valid only for this
command when the -help option is used.
o
source <value>—This option specifies the target from which the binary image is transferred.
The value specified must be a valid URL. The format is //tftpserverip/path/filename.
This option is required in the command line when you execute the load command unless you
use -help. The file must be an uncompressed firmware image file that you create using the DOS
ROMPAQ utility found on the Lights-Out 100 Firmware Upgrade Diskette Utility. You can
download the utility from the HP website
).
To create the uncompressed image file, enter the following command from DOS:
ROMPAQ /D <infile> <outfile>
where <infile> is the ROMPAQ firmware image file and <outfile> is the filename for the
uncompressed binary image file.
o
-examine—This option validates command formats.
The load command returns any status data on the first lines. After the status data appears, one of
the following lines of text appears on the next line:
—
<URL> transferred to <target address> (if the file is transferred)
—
<URL> not transferred (if the file is not transferred)
Example:
load -source //192.168.2.1/pub/firmwareimage.bin -oemhpfiletype csr