HP ProLiant DL145 G3 Server - Manual (Page 25)

Using LO100 25
Specific commands
CLP syntax for specific commands is found in the sections that also describe the functionality through the
browser interface.
To turn on or off the server LED1 (UID):
1. Browse to the /./system1/led1/-> directory.
2. Enter the following command:
set led1 enabledstate=enabled or disabled
To view a license key:
1. Browse to the /./map1/-> directory.
2. Enter the following command:
show
To display the firmware version:
1. Browse to the /./map1/firmware/-> directory.
2. Enter the following command:
show
IPMI 2.0 support
LO100 supports the industry-standard IPMI 2.0. The IPMI specification defines standardized, abstracted
interfaces that can be used for monitoring and control functions that are built in to the platform hardware.
In addition to supporting the mandatory commands for IPMI 2.0, the following additional IPMI 2.0
features are supported by LO100:
• Additional IPMI 2.0 commands
o Get Channel Cipher Suites
o Set/Get Channel Security Keys
o Suspend/Resume Payload Encryption
• Payload types
o IPMI Message
o RMCP+ Open Session Request/Response
o RAKP Message 1 / 2
o RAKP Message 3 / 4
• Authentication algorithms
o RAKP-none
o RAKP-HMAC-SHA1
• Integrity algorithms
o None
o HMAC-SHA1-96
• Confidentiality algorithms
o None