HP ProLiant DL145 G3 Server User Manual
Page 50
Using LO100 50
4.
To set your network BIOS settings, choose one of these options:
o
On ProLiant ML110 G4 and ML150 G3 servers:
a.
Press the down arrow (↓) key to scroll to the end, and select DHCP IP Source.
b.
Set DHCP IP Source to Disabled.
c.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On ProLiant ML115 G1 servers:
a.
Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press the Enter key.
b.
Press the down arrow (↓) key to scroll to the end, and select DHCP IP Source.
c.
Set DHCP IP Source to Disabled.
d.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On ProLiant DL140 G3 and ProLiant DL145 G3 servers:
a.
Press the down arrow (↓) key to scroll to the LAN Settings submenu. Press the Enter key.
b.
Set the IP Address Assignment to Static. This setting enables you to modify a static IP address
through the BIOS Setup menu.
c.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab or period (.) key to move between address fields).
5.
Press the F10 key to save and exit.
To enable a DHCP assigned address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (→) key to navigate to the Advanced menu.
3.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
4.
Choose one of these options:
o
On ProLiant ML110 G4 and ProLiant ML150 G3 servers:
a.
Press the down arrow (↓) key to scroll to the end and select DHCP IP Source.
b.
Set DHCP IP Source to Enabled.
o
On ProLiant ML115 G1 servers:
a.
Press the down arrow (↓) to scroll to the BMC LAN Configuration menu. Press the Enter key.
b.
Set DHCP IP Source to Enabled.
o
On ProLiant DL140 G3 and ProLiant DL145 G3 servers:
a.
Press the down arrow (↓) key to scroll to the LAN Settings submenu. Press the Enter key.
b.
Set the IP Address Assignment to DHCP.
5.
Press the F10 key to save and exit.
To enable telnet and HTTP services:
On ProLiant DL145 G3 servers, HTTP and telnet enabled by default. On ProLiant ML110 G4, ProLiant
ML115 G1, and ProLiant ML150 G3 servers, HTTP and telnet are enabled after installing the HP ProLiant
Lights-Out 100c Remote Management Card.
To enable telnet and HTTP on ProLiant DL140 G3 servers:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.