AT&T NORTEL BCM50 - Manual (Page 11)

AT&T IP Flexible Reach Service
Nortel BCM50 Release 3.0 SIP Configuration Guide
© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners.
4 Configuration Guide
This configuration guide specifies the Nortel BCM50 screens that must be
configured and updated to support the AT&T IP Flexible Reach service.
4.1 Nortel BCM50 Version and Feature Requirements
The Nortel Networks BCM50 must be running at least software version
6.0.2.05.237. You can check the version of BCM50 by viewing the following
screen under Administration Æ Software Management Æ Software
Update History .
Figure 2: BCM50 Software Version Number
This is the supported base release that is required for AT&T IP Flexible Reach
service. Any 6.0.x.x.x software release greater than the aforementioned
software version is acceptable.
This software release 6.0.x.x.x refers to BCM50 Release 3.0 SIP.
Issue 0.7 Page 11 of 37