AT&T NORTEL BCM50 User Manual

Page 9

Advertising
background image

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide


© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners.

o

12 digital station ports supporting digital phones.

o

4 Analog Loop Supervised Trunks (NA networking standards).

o

4 Analog Station interfaces with message waiting and CLID

support.

o

3 port 10/100 Ethernet switch with auto sensing and auto polarity.

Two of these ports also support connection of optional expansion

units.

o

1 10/100 Ethernet port reserved for direct access management of

the system

o

Integrated CallPilot voice mail system

o

T1 voice card for connection to the local PSTN.

* RFC2833 DTMF is currently not supported on the IP Softphone 2050; thus the
IP Softphone 2050 is not supported for AT&T IP Flexible Reach service. This will

be fixed in the next major release of the IP Softphone 2050 (release 3).


The following routing scenarios are supported by the Nortel BCM50 IP PBX and

DO NOT use the AT&T Call Control.


• Local Nortel BCM50 phone to other local Nortel BCM50 phone


The following routing scenarios are supported by the Nortel Networks BCM50 IP

PBX and DO use the AT&T Call Control. For voice calls, the G.729 codec shall be

used.

• Nortel BCM50 phones to PSTN (domestic US and international).

• Nortel BCM50 phones to legacy PBX site with Cisco gateway.

• Legacy PBX site with Cisco gateway to Nortel BCM50 phones.

• Nortel BCM50 phones at one Nortel BCM50 IP PBX site to Nortel BCM50

phones at another Nortel BCM50 IP PBX site

If the customer has subscribed to Calling Plans B and C (Local), then the
following routing scenarios are supported by the BCM50 IP PBX and DO use the

AT&T Call Control. For voice calls, the G.729 or G.711 codec may be used.
BCM50 selects G.729 as the highest priority codec.

• Inbound PSTN to BCM50 phone

• Outbound local PSTN calls from the BCM50 phones

• Outbound local N11 (i.e. 411, 911) calls from the BCM50 phones

Issue 0.7

Page 9 of 37

Advertising