AT&T NORTEL BCM50 - Manual (Page 20)

AT&T IP Flexible Reach Service
Nortel BCM50 Release 3.0 SIP Configuration Guide
© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners.
Under Configuration Æ Telephony Æ Dialing Plan Æ Routing , select the
“Destination Codes” tab to assign a destination code for the IP trunks.
Configure a destination code “9” or to whatever code you want to access for
outside (IP off-net) call that will be presented to the AT&T service for routing. In
this case, when “9” is dialed we wish to push the dialed string to the IP trunk for
routing. See figure below.
Note: When completing the Technical Questionnaire Section 6.0 Dial Plan
Information and the private dial plan is selected (YES), then please refer to
Appendix ‘A’: Configuring Destination Code with Wildcard .
Figure 12: Assign Code to Access IP Trunk Routes
Issue 0.7 Page 20 of 37