HP ProLiant SL2x170z G6 Server - Manual (Page 48)

Press the down arrow (
↓) key to scroll to the end, and select BMC LAN Configuration.
a.
b.
On BMC LAN Configuration, select Static.
c. Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab key to move between address fields).
•
On DL160 G6, DL160se G6, SL165s G7DL170h G6, DL170e G6, DL180 G6, SL160z
G6, SL170z G6, SL170s G6, SL2x170z G6, DL165 G7, SL165s G7, and SL165z G7
servers:
a.
Press the down arrow (
↓) key to scroll to scroll to the LAN Configuration menu. Press
the Enter key.
b. On DHCP IP Source, select Disabled.
c. Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab or period (.) key to move between address
fields).
5. Press the F10 key to save and exit.
To enable a DHCP assigned address:
1. Press the F10 key during POST to enter the BIOS Setup Utility.
2. Press the right arrow (
→) key to navigate to the Advanced menu.
3. Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
4. On ML110 G6 and DL120 G6 servers, press the down arrow (
↓) key to scroll down to LAN
Settings, press the Enter key, and then IP Address Assignment to DHCP.
5. BIOS settings for DL170h G6, SL170z G6, and SL2x170z G6 servers are set by default. To
set your network BIOS settings for other G6 servers, choose one of these options:
•
On ML150 G6 servers:
Press the down arrow (
↓) key to scroll to the end, and select BMC LAN Configuration.
a.
b.
Set DHCP IP Source to Static.
•
On DL160 G6, DL160se G6, DL180 G6, and SL160z G6 servers:
a.
Scroll to the LAN Configuration menu by pressing the down arrow(
↓) key. Press the
Enter key.
b. Set DHCP IP Source to Enabled.
6. To save and exit, press the F10 key, or to view the new IP Address, allow the server to reset
and reenter the BIOS Setup Utility.
Configuring network settings using the CLP
1. Log in to LO100 CLP as described in “Logging in to LO100” (page 25) .
2. At the command prompt, enter cd map1/nic1.
3. Configure the network settings by entering the following: set <network property>=<new
setting>
. Configurable valid network properties are:
•
networkaddress specifies the IP address for the NIC. This setting is dynamic.
•
oemhp_nonvol_networkaddress specifies the IP address stored in non-volatile memory.
•
oemhp_mask specifies the subnet mask for NIC. This setting is dynamic.
•
oemhp_nonvol_mask specifies the subnet mask stored in non-volatile memory.
•
oemhp_gateway specifies the gateway IP address for the NIC. This setting is dynamic.
•
oemhp_nonvol_gateway specifies the gateway IP address stored in non-volatile memory.
•
oemhp_dhcp_enable specifies whether DHCP is enabled for the NIC. Boolean values are
accepted
48 Using LO100