HP Photosmart C4380 All-in-One Printer - Manual (Page 109)

Solution: Turn the computer on.
Cause: The HP All-in-One is not properly connected to the computer.
Solution: Check the connection from the HP All-in-One to your computer. Verify
that the USB cable is securely plugged into the USB port on the back of the HP All-
in-One. Make sure the other end of the USB cable is plugged into a USB port on your
computer. After the cable is connected properly, turn the HP All-in-One off and then
on again.
For more information on setting up the HP All-in-One and connecting it to your
computer, see the Setup Guide that came with the HP All-in-One.
Wireless setup troubleshooting
This section addresses problems you might encounter setting up a network. Check the
device display for specific error messages.
This section contains the following topics:
• During wireless network setup you do not see the SSID (network name) displayed
• Weak signal
• Cannot connect to network during setup
• Invalid WEP key during wireless setup
• Invalid passphrase during wireless setup
• The Printer Not Found screen appears during installation
During wireless network setup you do not see the SSID (network name)
displayed
Cause: Your wireless router is not broadcasting its network name (SSID) because
the Broadcast SSID option is turned off.
Chapter 13
108 Troubleshooting
T
roub
les
hoot
ing