HP Photosmart C4380 All-in-One Printer - Manual (Page 18)

Integrated wireless WLAN 802.11 network setup
Use this section if you want to connect the HP All-in-One to a computer on a wireless
network using a wireless router or access point (802.11). HP recommends this method.
To set up the HP All-in-One on an integrated
wireless WLAN 802.11 network, you need to
do the following: See this section:
First, collect all of the required materials. “What you need for an integrated wireless
WLAN 802.11 network” on page 17
Next, install the software and connect the
HP All-in-One to the wireless router. “Connect to an integrated wireless WLAN
802.11 network” on page 18
What you need for an integrated wireless WLAN 802.11 network
To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will
need the following:
❑ A wireless 802.11 network that includes a wireless router or access point.
❑ A desktop computer or laptop with either wireless networking support, or a network
interface card (NIC). The computer must be connected to the wireless network that
you intend to install the HP All-in-One on.
❑ Broadband Internet access (recommended) such as cable or DSL.
If you connect the HP All-in-One on a wireless network that has Internet access, HP
recommends that you use a wireless router (access point or base station) that uses
Dynamic Host Configuration Protocol (DHCP).
❑ Network name (SSID).
❑ WEP key or WPA Passphrase (if needed).
Connect to a network 17
Finish
set
up