HP Surestore 6.140 Tape Library - Manual (Page 21)

Getting Started
Installing the Library (for Authorized Service Personnel only)
Chapter 1 1-5
G
e
ttin
g
S
tar
te
d
Installing the Library (for Authorized Service
Personnel only)
NOTE The power cord is factory installed. Libraries that are shipped to
Argentina, Brazil, Chile, China, Hong Kong, Israel, Laos, Paraguay,
Peru, Philippines, Singapore, and Thailand will have a stripped power
cord. The appropriate connector must be installed by an electrician.
Installation Overview
Below are the steps involved in setting up the library. These steps are
explained in more detail on the following pages.
• Choose a location.
• Unpackage the library.
• Install the host bus adapter(s) and drivers.
• Connect the host SCSI cables.
• Connect the Fibre Channel cables (if the library is configured for
Fibre Channel).
• Connect the remote management card to the LAN.
• Connect the power cable.
• Power on the library, peripherals, and the host.
• Configure the host system.