HP Surestore 6.140 Tape Library - Manual (Page 45)

Getting Started
Configuring the Host System
Chapter 1 1-29
G
e
ttin
g
S
tar
te
d
3. Boot the system. At the MPE prompt, run sysgen and start the io
section:
sysgen
SYSGEN version E . . .
sysgen> io
** IO configurator commands **
4. If not already configured, configure the differential card and the
pseudo/target level of the SCSI path:
io> apath 10/4/4 id=HP28696A
io> apath 10/4/4.0 id=pseudo
io> apath 10/4/4.1 id=pseudo
io> apath 10/4/4.2 id=pseudo
io> apath 10/4/4.3 id=pseudo
io> apath 10/4/4.4 id=pseudo
5. Configure the robotics controller and the drives (the pass-thru
driver):
io> adev 30 id=HPA4669A path=10/4/4.0.0
io> adev 31 id=DLT8000 path=10/4/4.1.0 mode=autoreply
io> adev 32 id=DLT8000 path=10/4/4.2.0 mode=autoreply
io> adev 33 id=DLT8000 path=10/4/4.3.0 mode=autoreply
io> adev 34 id=DLT8000 path=10/4/4.4.0 mode=autorepl y
6. Verify the bindings between PATH , LDEV number, ID , PMGR (device
drivers), and LMGR attributes for each device configured.
a. Verify the binding for the device adapter (the fw/differential dam):
io> lpath 10/4/4.0.0
PATH: 10/4/4 LDEV:
ID: HP28696A TYPE: DA
PMGR: FWSCSI_DAM PMGRPRI: 6
LMGR: MAXIOS: 0
Repeat this step for lpath 10/4/4.1 , 4.2 , 4.3 , and 4.4 .