HP Surestore 6.140 Tape Library - Manual (Page 44)

Getting Started
Configuring the Host System
Chapter 1 1-28
MPE/iX Hosts
Requirements
Libraries require additional Legato NetWorker Server software that
runs on either an HP Intelligent Server or an NT Server. The HP 3000
must be a Legato Networker Storage Node.
Configuring the Host
The example below illustrates the steps needed to configure the library
on MPE/iX.
NOTE This example illustrates the driver binding, but is not optimized for
performance since it shows the entire library on a single differential bus.
NOTE The library ID of A4669A is used only as an example. The actual RUN
MAPPER output reflects the product number of your library.
1. Power on the library and host. Run ODE at the ISL prompt:
ISL>ODE
2. Identify the device path through RUN MAPPER :
ODE> RUN MAPPER
***STARTING EXECUTION OF MAPPER****
Processor Identification:
...
I/O Configuration:
Type HW SW Revisions
Path Component Name ID Mod Mod Hdwr Firm
...
/4/4 HP-PB Fast Wide SCSI . . .
/4/4.0.0 A4669A . . .
/4/4.1.0 DLT8000 . . .
/4/4.2.0 DLT8000 . . .
/4/4.3.0 DLT8000 . . .
/4/4.4.0 DLT8000 . . .