HP Surestore 6.140 Tape Library - Manual (Page 39)

Getting Started
Configuring the Host System
Chapter 1 1-23
G
e
ttin
g
S
tar
te
d
2. Type “init 0” at any prompt. This will shut down all processes, and
take you to the OpenBoot PROM.
3. Type “reset”.
4. At the OK prompt, type “probe-scsi-all”.
Run a test backup to ensure that all components are properly configured.
HP-UX Hosts
To enable communication between the host and tape library, appropriate
drivers must be configured into the HP-UX kernel. Table 1-6 shows
which drivers are necessary for each device.
NOTE Some drivers have different names, depending on whether or not they are
listed in the output of an ioscan or in the system file.
Table 1-6 Drivers Needed
Device Driver Name
In ioscan In system
file
SCSI Host Bus Adapter
(HSC or PCI Bus) c720 c720
Fibre Channel Host Bus Adapter
fcp fcT1_fcp
fcT1 fcT1
fcT1_cntl fcT1_cntl
Fibre Channel Bridge or Multiplexer fcpmux fcpmux
Tape Library Robotics Controller
(HSC or PCI Bus) sctl sctl
Tape Driver (HSC or PCI Bus) stape stape