HP StorageWorks 8000 NAS - Manual (Page 220)

218 Command View SDM Limitations
Configuration
(cont.)
Rebuild Priority This is set to Low. If a rebuild is required,
you may wish to alter this setting to allow
the rebuild to proceed more quickly. This
may result in a degradation of user
performance.
Type Do not changes this setting. Rebuilds are
set to automatically occur when required.
Start/Stop Disabled unless Manual Rebuild is
selected.
Diagnostics Array Shutdown This “turns off” I/O do the array but does
not power it down. Doing so without
stopping I/O at the NAS server (e.g.
turning off all shares/mounts) will cause
clients to have I/O failures. Be sure you
understand the affects of this operation
before using it. The NAS 8000 operating
system will automatically start this feature
when it boots.
Full Reset This feature should not be required in
normal operation. Resetting the array can
take several minutes. During this time, I/O
requests from the NAS server may time
out.
Partial Reset This feature should not be required in
normal operation. This takes less time than
a full reset; however, I/O requests from
the NAS server may still time out.
Restart The inverse of the “Shutdown” operation.
It turns back on I/O to the device.
Disk Include This feature is enabled in the Command
View NAS web interface.
Table 1 Command View SDM Limitations
Tab Page Feature Limitations